Emerson Network Router Bedienungsanleitung PDF herunterladen (Seite 38)

32 ProLink

II Software for Micro Motion

Transmitters

Using ProLink II Software

3.8 Viewing meter status

ProLink II allows you to view a variety of status information:

•

Connection LED – located in the lower right corner of the main window (see Figure 3-2).

This LED indicates the status of the connection between ProLink II and the transmitter:

- Green – Good connection

- Red – Connection fault

- Gray – No connection

•

Device Fault Status LED – located in the lower right corner of the main window (see

Figure 3-2). This LED indicates whether or not alarms are active:

- Green – No active alarms

- Red – One or more active alarms

- Gray – Unknown

See Section 3.9 for more information about alarms.

•

Diagnostic Information window – displays sensor diagnostic data

•

Output Levels window – displays current data for the transmitter’s mA, frequency, and

discrete outputs, and also displays discrete event status

•

Status window – displays alarm status. See Section 3.9 for more information about alarms.

•

Alarm Log window – displays alarm status and alarm acknowledgment status. See Section 3.9

for more information about alarms.

•

Core Processor Diagnostics window – displays detailed diagnostic data for the core

processor component

Note: The Core Processor Diagnostics window is read-only. If changes are required, contact

Micro Motion.

•

FingerPrint window – displays detailed information for both process variable data and sensor

diagnostic data

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 95 96

Keine Kommentare

Emerson Network Router Bedienungsanleitung Seite 38