Emerson FM-3 Installationshandbuch PDF herunterladen (Seite 150)

136

FM-3 Programming Module Reference Manual

To select one of the individual setup views, click on the element in the hierarchy view. The

element will then be highlighted, and the right side of the view will show all setup parameters

for that subject. Figure 2 shows the Setup view selected.

Figure 57: General Setup View

On this view, you must enter the following parameters before entering other setup views:

Drive Type – Select, from the list box, the type of drive to which the FM-3 is attached.

Motor Type – Select, from the list box, the type of motor being used in this application.

Line Voltage – Select, from the list box, the line voltage applied (115VAC or 230VAC).

Target Drive Address – Enter the Modbus address for this drive/FM-3 system. PowerTools

FM-3 will download the configuration to that specific drive only.

Please take the time to check that these parameters are correct.

User Units View

Determine which types of units the drive should use to measure motion and enter them on this

view. Figure 3 shows the Setup group in the hierarchy expanded with the User Units element

selected.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 229 230

Keine Kommentare

Emerson FM-3 Installationshandbuch Seite 150