Emerson VSG & VSSG Spezifikationen PDF herunterladen (Seite 41)

GATE ROTOR BLADE INSTALLATION

A) Install damper pin bushing (120) in gate rotor

blade (111) from the back side of the blade. Be

sure the bushing is fully seated.

B) Place the blade assembly on the gate rotor sup-

port. Locating Damper over pin.

C) Install washer (119) and snap ring (130) on gate

rotor assembly. The bevel on the snap ring must

face away from the gate rotor blade. After the

gate rotor blade and support are assembled,

there should be a small amount of rotational

movement between the gate rotor and support.

D) For installation of the gate rotor assembly and

setting of gate rotor clearance, refer to section

INSTALLATION (All VSG 301-701 Models).

GATE ROTOR THRUST BEARING REMOVAL

A) Refer to section INSTALLATION (All VSG Models)

for removal of the gate rotor bearing housings

and gate rotor supports.

B) For removal of thrust bearings on VSG units:

1) Remove bolts (150) from the clamping ring

(114).

2) Remove thrust bearing clamping ring.

3) Remove thrust bearings (126) from housing

(113).

C) For removal of thrust bearings on VSSG units:

1) Remove retaining ring from gate rotor sup-

port.

2) Remove bearings from support.

3) Remove bearing retainer from inner race.

Service

(with Relief)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 99 100

Keine Kommentare

Emerson VSG & VSSG Spezifikationen Seite 41