Emerson easy-Drive Installationshandbuch PDF herunterladen (Seite 10)

Instruction Manual

D103597X012

D4 Valve with easy-Drive Actuator

November 2013

Figure 4. Wiring - Analog Input

Analog Input

(420mA: 40033=1, 40034=1, 40043=0

(1)

)

1. Connect signal to terminal 3

2. Connect reference t o terminal 4

3.Connect250ohm resistorbetween

terminals 3 and 4 as shown.

NOTE:

1. 40043=0 SETS ANALOG INPUT TO 1-5V AND ASSUMES USE OF RECOMMENDED EXTERNAL 250 OHM RESISTOR.

IF NO EXTERNAL RESISTOR IS USED, SET 40043=1.

Figure 5. Wiring - L2e

L2e (dual dry contact:

40033=0, 40034=0, 40043=0)

1. Connect L2e brown wire to terminal 1 (COMM (com))

2. Connect L 2e red wire to terminal 2 (N.O. (OPEN))

3. Connect L2e blue wire to terminal 3 (N.C. (CLOSE))

Your actuator may be labelled:

1. COMM

2. N.O.

3. N.C.

1. com

2. OPEN

3. CLOSE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Keine Kommentare

Emerson easy-Drive Installationshandbuch Seite 10