63
Rosemount 3051
September 2014
www.rosemount.com
FCC and IC
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following conditions: This device may not cause
harmful interference. This device must accept any interference
received, including interference that may cause undesired
operation. This device must be installed to ensure a minimum
antenna separation distance of 20 cm from all persons.
Ordinary Location Certification for FM
As standard, the transmitter has been examined and tested to
determine that the design meets basic electrical, mechanical,
and fire protection requirements by FM, a nationally recognized
testing laboratory (NRTL) as accredited by the Federal
Occupational Safety and Health Administration (OSHA).
North American Certifications
Factory Mutual (FM) approvals
I5 FM Intrinsically Safe
Certificate No: 3046325
Applicable Standards: Class 3600:2011, Class 3610:2010,
Class 3810: 2005, ANSI/ISA 60079-0 2009,ANSI/ISA
60079-11:2009 ANSI/NEMA 250:2003, ANSI/IEC
60529:2004
Markings: Intrinsically Safe for Class I, Division I, Groups A,
B, C, D
Zone Marking: Class I Zone 0, AEx ia IIC
T4 (-40 °C to 70 °C)
Intrinsically Safe when installed according to Rosemount
Drawing 03031-1062
Enclosure Type 4X/IP66/IP68/IP67
Special Conditions for Safe Use (X):
1. The inline pressure sensor may contain more than 10%
aluminum and is considered a potential risk of ignition by
impact or friction. Care must be taken into account during
installation and use to prevent impact and friction.
2. The surface resistivity of the transmitter is greater than
one gigaohm. To avoid electrostatic charge build-up, it
must not be rubbed or cleaned with solvents or a dry cloth.
3. The Model 3051 Wireless Pressure Transmitter shall only
be used with the 701PGNKF Rosemount SmartPower
Battery Pack.
CSA - Canadian Standards Association
I6 CSA Intrinsically Safe
Certificate No: 2526009
Applicable Standards: CSA C22.2 No. 0-M91, CSA C22.2
No. 94-M91, CSA C22.2 No. 142-M1987, CSA C22.2 No.
157-92, CSA C22.2 No. 60529-05
Markings: Intrinsically Safe For Class I, Division I, Groups A,
B, C, D
T4 (-40 °C to 70 °C)
Intrinsically safe when installed according to Rosemount
drawing 03031-1063
Enclosure Type 4X/IP66/IP68
European Certifications
I1 ATEX Intrinsic Safety
Certificate No: Baseefa12ATEX0228X
Applicable Standards: EN60079-11:2012,
EN60079-0:2012
Markings: Ex ia IIC T4 Ga (-40 °C Ta 70 °C)
II 1G
IP66/68
1180
Special Conditions for Safe Use (X):
1. The plastic enclosure may constitute a potential
electrostatic ignition risk and must not be rubbed or
cleaned with a dry cloth.
I7 IECEx Intrinsic Safety
Certificate No: IECEx BAS 12.0124X
Applicable Standards: IEC60079-11:2011,
IEC60079-0:2011
Markings: Ex ia IIC T4 Ga (-40 °C Ta 70 °C)
IP66/68
Special Conditions for Safe Use (X):
1. The plastic enclosure may constitute a potential
electrostatic ignition risk and must not be rubbed or
cleaned with a dry cloth.
2. The Model 701PGNKF Power Module may be replaced in a
hazardous area. The Power Module has a surface resistivity
greater than 1G and must be properly installed in the
wireless device enclosure. Care must be taken during
transportation to and from the point of installation to
prevent electrostatic charge build-up.
(124 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern