Emerson SW375 Bedienungshandbuch PDF herunterladen (Seite 8)

21. Position the receiver by passing the opening in

the receiver over the hanger pipe (Figure 14A).

22. Connect the black wire from the wiring harness to

the black (hot) supply wire (Figure 6A). Connect

the white wire from the wiring harness to the white

(neutral) supply wire. Connect the green ground

wires from the hanger bracket and the hanger ball

to the supply ground wire. Use wire connectors

(supplied).

23. Securely connect the wiring harness connector to

the receiver connector, and connect the blue and

yellow wires from the downrod to the blue and

yellow wires from the receiver (Figure 6A).

24. Fold and position the wires into the space above

the hanger ball and into the outlet box

(Figure 14A).

25. Feed the wires and connectors through the open

side of the hanger bracket, and into the outlet

box. Slide the receiver up and over the hanger

bracket. Press the receiver against the ceiling and

hold it in place. Then lift the ceiling cover up to the

threaded studs and turn until studs protrude

through the holes in the ceiling cover

(Figure 15A).

26. Secure the ceiling cover in place by sliding

lockwashers (supplied) over the threaded studs and

installing the two knurled knobs (supplied).

(Figure 15A.) Tighten the knurled knobs securely

until the ceiling cover fits snugly against the ceiling

and the hole in the ceiling cover is clear of the

downrod.

29. Attach one blade assembly to the motor hub using

two 10-32 x 5/8” oval head screws (supplied)

(Figure 17A). Do not tighten completely at this time.

Install remaining blade assemblies in the same

way. Gently snug all flange screws to the motor

hub, working around the hub in a clockwise

sequence. Next, securely tighten all flange screws,

again working in a clockwise sequence. Failure to

follow this procedure could result in fan wobble.

This completes the blade installation.

30. Pass the connectors and the wires form the motor

shaft through the washer (supplied) and position the

washer over the motor shaft (Figure 17A).

1-1/4"

THREADED

STUD

LOCKWASHERS (2)

CEILING COVER

KNURLED KNOB

Figure 15A

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the outlet box and

not pinched between the ceiling cover and the ceiling.

WARNING

BLADE

FLANGE

10-32 x 3/8"

PAN HEAD SCREW

FLAT WASHER

FAN BLADE

Figure 16A

MOTOR HUB

BLADE FLANGE

10 - 32 x 5/8"

OVAL HEAD SCREW

(2 Per Blade Assembly)

WASHER

MOTOR

SHAFT

Figure 17A

HANGER

BRACKET

HANGER

BALL

CEILING COVER

SW375

RECEIVER

OPEN

SIDE

1-1/4" THREADED

STUD

Figure 14A

27. Use three 10-32 x 3/8” pan head screws and flat

washers (supplied) to secure the flange to the

blade (ordered separately) (Figure 16A). Repeat for

the four remaining blades.

28. Use the 10 round recessed holes in the motor hub

marked with “5” and install the five blade

assemblies in accordance with Step 29.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Emerson SW375 Bedienungshandbuch Seite 8

Kommentare zu diesen Handbüchern