READ AND SAVE THESE INSTRUCTIONSRaphael Model No.CF2600AB01CF2600WB01CF2600PW01Raphael II Model No.CF2650BC01CF2650WB01CF2650PW01RAPHAEL™/ RAPHAEL II™
8. Install the setscrew (supplied) in the motor couplingand tighten using the 5/32” setscrew wrench(supplied) (Figure 3B).9. Screw two 1” threaded stu
10. Position the ceiling cover over the downrod. Besure the cover is oriented correctly, with the largeopening at the top (Figure 5B).11. Reinstall th
15. Carefully lift the fan and seat the hangerball/downrod assembly on the hanger bracket thatwas just attached to the outlet box (Figure 9B). Besure
21. Attach one blade assembly to the motor hub usingtwo 10-32 x 5/8” oval head screws (supplied)(Figure 13B). Do not tighten completely at this time.I
14Installation of the Decorative Support Rods AssemblyNOTE: The following procedures are to beperformed only if you have installed the 18” orlonger do
15Using Your Ceiling Fan1. Restore electrical power to the outlet box byturning the electricity on at the main fuse box.2. Check the operation of the
Printed in Taiwan 04/03Part No. F40BP72510004 Form No BP7251-4Repair Parts ListingRaphael Part Numbers Raphael II Part NumbersKey Model No. Model No
2WARNING!WARNING: To avoid fire, shock, and serious personal injury, follow these instructions.Safety Instructions1. Read your owner’s manual carefull
1. Open carton containing your ceiling fan. Removethe top half of the styrofoam packing. Removeparts and check to see that you have received thefollow
If your fan is to replace an existing ceiling light fixture,turn electricity off at the main fuse box at this timeand remove the existing light fixtur
5SECTION AAssembly Instructions for Installing theCF2600 and CF2650 Ceiling Fan with the EmersonSR330 Remote Control or the SW350 Wall Control1. Obtai
611. Fold the wires from the downrod into the slot inthe motor coupling (Figure 5A). Then slide thedownrod down the wires and seat the downrod inthe m
7DOWNRODPINHANGER BALLCEILING COVERFigure 9A17. Screw in four 60-watt (maximum) candelabra baselamps in the housing sockets (Figure 10A). Graspthe soc
21. Position the receiver by passing the opening inthe receiver over the hanger pipe (Figure 14A).22. Connect the black wire from the wiring harness t
31. Using the 5/64” hex wrench (supplied), loosen thesetscrew in the collar on the light kit adapterassembly. Then pass the connectors and the wiresfr
Kommentare zu diesen Handbüchern