Emerson SW375 Bedienungshandbuch PDF herunterladen (Seite 7)

DOWNROD

HANGER BALL

CEILING COVER

Figure 9A

17. Screw in four 60-watt (maximum) candelabra base

lamps in the housing sockets (Figure 10A). Grasp

the sockets and pivot them until the lamp bulbs are

even with the top of the housing as shown. This will

provide the optimum lighting effect.

18. Securely attach the hanger bracket to the outlet

box using the two screws supplied with the

outlet box (Figure 12A).

The outlet box must be securely anchored and capable

of withstanding a load of at least 50 lbs.

WARNING

The fan must be hang with at least 7’ of clearance from

floor to blades (Figure 11A).

WARNING

AT LEAST

FLOOR

Figure 11A

To reduce the risk of fire, electric shock, or personal

injury, mount fan to outlet box marked acceptable for

fan support, and use screws supplied with outlet

box. Most outlet boxes commonly used for support

of light fixtures are not acceptable for fan support

and may need to be replaced. Consult a qualified

electrician if in doubt.

WARNING

Hanger bracket must seat firmly against outlet box. If

the outlet box is recessed, remove wall board until

bracket contacts box. If bracket and/or outlet box are

not securely attached, the fan could wobble or fall.

WARNING

TWO SCREWS

SUPPLIED WITH

OUTLET BOX

HANGER

BRACKET

TAB

OUTLET

BOX

Figure 2

Figure 12A

TOP OF

HOUSING

CANDELABRA

BASE LAMP

SOCKET

Figure 10A

19. Carefully lift the fan and seat the hanger

ball/downrod assembly on the hanger bracket that

was just attached to the outlet box (Figure 13A).

Be sure the groove in the box is lined up with tab

on the hanger bracket (Figure 12A).

20. Screw two 1-1/4" threaded studs (supplied) into

the tapped holes in the hanger bracket

(Figure 14A).

Failure to seat tab in groove could cause damage to

electrical wires and possible shock or fire hazard.

WARNING

OUTLET

BOX

HANGER

BRACKET

HANGER BALL/

DOWNROD ASSEMBLY

Figure 3

NOTE: CEILING COVER,

SUPPLY WIRES AND

FAN WIRES OMITTED

FOR CLARITY.

Figure 13A

To avoid possible fire or shock, do not pinch wires

between the hanger ball/downrod assembly and the

hanger bracket.

WARNING

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before wiring.

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice,

as it must be grounded for safe operation.

WARNING

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Emerson SW375 Bedienungshandbuch Seite 7

Kommentare zu diesen Handbüchern