Emerson 299H Installationshandbuch Seite 1

Stöbern Sie online oder laden Sie Installationshandbuch nach Nein Emerson 299H herunter. Emerson 299H Installation Instructions Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
D300902X012
Installation Sheet
Type 299H, 299HS, or S200
www.emersonprocess.com/regulators
March 2000
Installation
1. Remove disk holder assembly (key 16, Figure 1).
2. Press in the plastic boost cartridge assembly
(key 111, Figure 1) with both thumbs until it contacts
the end of the stem guide inside the boost throat of
the lower casing.
Note
The top edge of the plastic boost
cartridge assembly should be
recessed 1/16 thru 1/8-inch (1,59 thru
3,17 mm) per Figure 1.
For Type S200 Only
3. If necessary, replace the metal vent seat
ring (key 58, Figure 2) in the spring case vent.
Replacement is not necessary for Type S200 regulators
shipped before 1985 or after October 1992.
Note
The new vent seat ring has only 1 small
hole (1/16-inch diameter (1,59 mm)) in
addition to the 3 screw holes. The old
vent seat ring had 3 larger holes
(5/32-inch diameter (4,00 mm)) in
addition to the 3 screw holes.
Type 299H, 299HS, or S200 Retro-Fit of
Stabilizing Parts
Kit Part Number RS200XRT012
19
111
16
CONTACT
CLIP
RECESSED
1/16 THRU 1/8-INCH
(1,59 THRU 3,17 mm)
58
Figure 1. Stabilizing Boost Cartridge
Figure 2. Vent Assembly in Spring Case
(not applicable for Types 299H and 299HS)
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - Stabilizing Parts

D300902X012Installation SheetType 299H, 299HS, or S200www.emersonprocess.com/regulatorsMarch 2000Installation 1. Remove disk holder assembly (key 16

Seite 2 - Type 299H, 299HS, or S200

Type 299H, 299HS, or S200The Emerson logo is a trademark and service mark of Emerson Electric Co. All other marks are the property of their prospectiv

Kommentare zu diesen Handbüchern

Keine Kommentare