Emerson FM-3 Betriebsanweisung PDF herunterladen (Seite 142)

123

Quick Start

3. Select the desired “Velocity Preset” number.

4. Enter a "Velocity Preset" for each "Preset Number" being used.

5. Enter an “Accel/Decel Presets” value for each "Preset Number" being used

Figure 102: Velocity Summation Submode

Torque Mode Setup

This procedure assumes that you have connected the proper analog command wiring as

described in the "Installation" section of this manual.

1. Select the “Torque Mode” radio button from the Operating Mode group.

Figure 103: Operating Mode, Torque Mode Selected

2. Enter a “Full Scale Torque” value. This "Full Scale Torque" value corresponds to an

Analog Full Scale parameter, which is defaulted to a 10V analog command.

Torque Limit Setup

This function can be active in any Operating Mode.

1. Enter a "Torque Limit" value. The "Torque Limit" is the value at which the Torque

Command will be limited when the "Torque Limit Enable" input function is active.

2. Click on the Inputs tab. Assign the "Torque Limit Enable" input function to an input line

by highlighting the function, then selecting one of the "Input Line Selection" radio

buttons or by dragging the highlighted input function to the desired input line.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 262 263

Keine Kommentare

Emerson FM-3 Betriebsanweisung Seite 142