Emerson Autochangeover Controllers AC8 Bedienungsanleitung PDF herunterladen (Seite 5)

Revision B.31 10/14/2009

Liebert Monitoring Group - Development

Page 5 of 146

How to use the Reference Library Charts

This document contains a dedicated sheet for each Liebert Unit and associated controller. The title of each chart

contains the name of the Liebert Controller used such as L00 for a Level-0 Air unit or PMP for a Power Monitoring

Panel for Power Center.

The first section, Compatible Hardware, indicates the equipment associated with this particular controller as follows:

Liebert Units Indicates the Environmental, Power, UPS or Monitoring Module by model name that

uses this controller.

SiteScan Interface

Modules

Indicates which SiteScan Hardware Modules can be used with the controller. Take

Special note of this box when adding new units to an existing SiteScan system, as

some new controllers are only compatible with the new hardware (SiteLink).

BMS interface Modules Indicates which SiteScan Hardware Modules can be used with the controller for

interfacing with a third part using BACnet or Modbus protocol.

The next section, Available Points, contains six categories providing the following information:

Status Points (View)

Status Information for the listed points that will be presented in SiteScan

Alarm Points

Alarms that are available to SiteScan

Setpoints (View)

Current settings of controllable Setpoints available to SiteScan

Control Points (Set)

Setpoints that can be changed with SiteScan

Trendable Points (Set)

Points that can be graphically trended within the SiteScan software

Reports

Reports that can be triggered within the SiteScan software

1 2 3 4 5 6 7 8 9 10 ... 145 146

Keine Kommentare

Emerson Autochangeover Controllers AC8 Bedienungsanleitung Seite 5