Emerson CMF200A Installationshandbuch PDF herunterladen (Seite 15)

Installation Manual 13

Mounting the Sensor

Figure 10 Mounting the temperature extender onto the sensor

Mounting the electronics of high-temperature and extreme high-temperature sensors

High-temperature and extreme high-temperature ELITE sensors come with a 32″ (812 mm) pre-installed

flexible conduit. This conduit is required for agency approval.

A factory-supplied Model 2400S transmitter, Model 1700/2700 transmitter, core processor, or junction box is

connected to the end of the flexible conduit. Mount the electronics to a wall or instrument pole using the

supplied bracket (Figure 11).

Extended mount — carefully align the notches at

the bottom of the extended mount with the

notches on the feedthrough to engage properly

Plastic plug — remove and

discard

Feedthrough — note the

notches for correct

engagement of the extender

Clamping ring screw —

when extender is engaged,

tighten this to 13–18 in-lbs

(1.5–2 N-m)

Model 2400S transmitter or enhanced core

processor — preinstalled on the extended

mount

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Keine Kommentare

Emerson CMF200A Installationshandbuch Seite 15