Emerson MONITORING OpenComms Bedienungsanleitung PDF herunterladen (Seite 7)

Opening a Service Terminal Connection

This section covers the Service Terminal in detail. From the Service Ter-

minal, you can configure all settings of the card.

NOTE: You can also configure many of the setting discussed in this sec-

tion from the Web. To specify that the card communicate at either 10Mbit

or 100Mbit instead of it trying to auto-negotiate, you must use the Service

Terminal

You access the Service Terminal by opening a direct serial connection to

the OpenComms Web Card.

1.Locate the blue serial configuration cable that shipped with the card.

NOTE: If you have misplaced the cable provided, you can use a standard

null modem cable with a DB-9F connector at both ends.

2.Connect one end of the blue serial configuration cable to the DB-9M

serial port on the OpenComms Web Card.

3.Connect the other end of the blue serial configuration cable to a termi-

nal or a PC running terminal emulator software, like HyperTerminal ™ or

ProComm ™.

4.Use the following communication settings:

BAUD RATE:9600

DATA BITS:8

PARITY:NONE

STOP BITS:1

FLOW CONTROL:NONE

Service Terminal

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Keine Kommentare

Emerson MONITORING OpenComms Bedienungsanleitung Seite 7