Emerson A31A Bedienerhandbuch Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 24
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
Cryogenic-Rotary Valve
Instruction Manual
Form 5482
February 2005
11
Figure 5. Typical Seal Installation
16B5081 / DOC
LARGEST OUTSIDE
DIAMETER (KEY 7)
Table 5. Torque Values for Fasteners
FASTENER NOMINAL
SIZE
RETAINING RING SCREWS GASKET RETAINING BOLTS
NSm InSlbs NSm InSlbs
#10 4.6 41 4.0 35
1/4 11 100 9.2 81
5/16 25 220 19 167
3/8 45 400 33 295
NSm ftSlbs NSm ftSlbs
7/16 72 53 53 39
1/2 112 83 80 59
9/16 161 119 117 86
5/8 225 166 161 119
3/4 401 296 286 210
7/8 651 480 447 330
1 976 720 651 480
1-1/8 1356 1000 837 617
Note: These values are based upon standard materials, S66286/Inconel screws and ASTM A193GRB6 bolts. For other special fastener materials, please contact your Fisher sales
office.
2. Install the seal ring, and if applicable back-up
ring, in the valve body by first placing the wider
outside diameter of the seal ring into the T-slot area
of the valve body as shown in figure 5.
3. Once the seal ring has been fully installed into
the valve body T-slot, the retaining ring gasket can
be installed. This gasket is a thin graphite material.
Use extreme care to avoid damaging the gasket
while punching one initial screw hole through the
gasket for alignment.
4. Install the retaining ring, and align the screw
holes in the retaining ring with the holes in the valve
body. Install the first retaining ring screw through the
punched hole in the retaining ring gasket. Install the
other retaining ring screws by pushing them through
the graphite gasket and threading them into the
valve body.
5. Tighten the retaining ring screws just enough to
eliminate any movement of the retaining ring. Do not
over-tighten the retaining ring screws.
WARNING
Avoid personal injury or property
damage caused by the impact of a
falling or tipping valve. Support large
valves during maintenance.
6. To complete this step, stand the valve up.
Support the valve securely using methods
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare