Emerson RC188 Bedienungshandbuch PDF herunterladen (Seite 4)

General

Your Emerson Ceiling Fan/Light SR650

Remote Control consists of hand-held

transmitter with wall mount and a receiver

which is mounted under the fan ceiling

cover. The remote control is designed to

separately control your ceiling fan speed

and light intensity.

The remote control transmitter is powered

by two CR2032 Lithium batteries

(inculded). Be sure to remove the batteries

when the control is not to be used for an

extended period of time.

Code switches in the transmitter and

receiver may be set in 32 different

positions. If your fan and light go on and

off without using your control, you may be

getting interference from other remote

SR650 REMOTE

CONTROL PROCEDURES

4

Setting Operating

Frequency of SR600

Remote Control

1. Slide the five switch levers in the

remote control to your choice of ON

(up) or down positions. Use a ball-point

pen or small screwdriver and slide the

levers firmly up or down.

2. When power is restored, push and hold

the fan OFF button ( ) for 3 to 5

seconds to set the code in the receiver.

3. If airflow is desired in the opposite

direction, press the ( ) button on the

wall control. The fan must be operating

at any speed for the reverse button to

function. The blades will turn in the

opposite direction and reverse the

airflow.

4. To set the desired fan speed, press the

( ) button to decrease the speed and

the ( ) to increase the speed. The

LED display will light up to indicate the

new speed selected.

5. To set the light intensity, press and

release the LIGHT ( ) button to

decrease the light intensity and the

LIGHT ( ) button to increase the light

intensity. The light will turn on at the

light intensity previously selected.

CODE

SWITCHES

SR600 REMOTE

CONTROL

BATTERY

COMPARTMENT

COVER

TWO AAA

BATTERIES

REMOTE CONTROL

LEVERS

ON

1

234

5

I

Figure 1

6. The sixth switch marked ON and I is for

dimming control of lights: Set switch to

ON to allow for dimming of the lights.

Set switch to I for no dimming of the

lights such as for fluorescent bulbs.

Your remote control has code switches

which must be set in one of 32 possible

code combinations. The five levers

(numbered 1, 2, 3, 4, and 5) on the

switches are factory-set in the ON (up)

position. Change the switch settings as

follows:

TO INSTALL BRACKET TO WALL:

SLIDE THE COVER UP TO EXPOSE THE SCREW

HOLES FOR INSTALLATION

COVER

WALL

BRACKET

SCREW

HOLES (2)

Figure 2

Installation of Storage

Bracket for SR600

Remote Control

A storage bracket is provided for holding

your remote control when not in use. If you

desire to use the bracket, install it on a

wall that is away from excess heat or

humidity (Figure 2).

BP7415 RC188 & RC212 Receiver 10/30/09 11:29 AM Page 4

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare